6/2/2023 0 Comments Yella terra rockers![]() The team concluded that its a small batch of arms machined with insufficient radius in a critical load area caused by incorrect tooling supply. This new HAAS produced arms overnight that got mixed in with the other arms from our existing machines- thus the difficulty in traceability. The Ratio is fine but the PR hole diameter was incorrect. On initial production of the HAAS, the pushrod cup was machined out of spec on some of the LS1 arms (only the 1.7 YT6645). All three machines output ( ie arms ) are conveyed to a single rumbler for finishing. In November/Dec 2008 we purchased a new HAAS to increase our production capacity to three machining centres making the LS arms. The root cause was a process and inspection issue. I'll follow the QA format request posted earlierġ) What has your team determined is the root cause of the problem? Weve done our CSI and have following information to provide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |