5/29/2023 0 Comments Ergosoft rip version 15 manual![]() ![]() ![]() When I set up the printer I did an initial fill with Piezoflush and let it sit for 48 hours, and then filled with the K7 inks and did an initial fill. I get the same sort of results on all matte papers that I have tried. I scanned each patch in i1Profiler to check I’m not going crazy, these are the results. I printed it on Ilford Cotton Artist Textured, a warm paper with no OBAs. I have attached a photo of it, it’s just a snap from my phone sorry. I have printed the 10 ink purge image from QTR in calibration mode with ink calibration on 100, 2880 dpi and unidirectional, I cropped it to save paper. This is happening on different papers, Hahnemuhle Photo Rag, Hahnemuhle German Etching, Canson Rag Photographique, Ilford Textured Cotton Rag and Ilford Cotton Artist Textured are what I have tried. I am using ErgoSoft V15 to run the printer and create our own setups for each paper.īasically my issue is that prints are too yellow in the lighter tones, slightly blue in the darker tones but then a nice neutral black. The black channel in the printer is permanently clogged so I have loaded the new Ultra HD Matte black in the orange slot and the new High Density Photo Black into green, I have Piezoflush in the MK and PK cartridges. I have recently converted our 9900 to run a set of K7 neutral inks, both matte and gloss.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |